パラコードでブレスレットの編み方 マッドマックス Paracord Shark jaw bone Bracelet


This time, I tried knitting Shark jaw bone knitted bracelet with para code. This time para cord was cut with about 1 m 80 cm for both colors. Close the length of 50 cm from the end with a washing cloth. Next, place the 50 cm side down. Make a loop with the right string, Lower the string on the left, Pass through the loop from the bottom. Remove the washing scissors. I will tighten the stitch. Introduction Left cord Through the right axis, I will make a circle. Next right string Pass under the left axis, Pass through the loop from the bottom. The second time is the opposite of the previous one, Pass under the left axis with the right string, The left string Pass under the right axis,
Pass through the loop from the bottom. I will weave it by repeating the operation so far. Please pay attention to excessive overtighting at the last two holes, since you will pass the string at the end. I will weave. I knitted. Cut the left and right extra parts, I will stop fraying with a writer etc. I will go through the string. With the size to get your hands on, I will make a knot. done. This way of knitting,
It features stitches that shark teeth are lining in. This video is also recommended. Subscribe thank you. Until the last minute, thank you for watching.

Comments 1

  • 今回はShark jaw boneという編み方に挑戦してみました。
    直訳すると、サメの顎の骨という意味で編み目がサメの歯に似ていることからそう呼ばれているようです。
    ご感想などコメントお待ちしてます♬
    チャンネル登録 よろしくお願いします。

Leave a Reply

Your email address will not be published. Required fields are marked *